PVC Vinyl Safety Wall Pad 2x6 Ft x 2 in WB Z-Clip ASTM: Indoor Padding

1. Certified OSB
2. Impact rated polyethylene foam
3. Class A fired PVC Vinyl
4. 2 inch thick foam
5. 18 oz vinyl covering
6. Leed certification
7. Contains at least 60% recycled pre-consumer raw material
8. Anti-Mildew, Anti-Fungus, Antimicrobial, Antibacterial treated

The right materials to make your project the very safest, it is certified OSB, Impact rated polyethylene foam, and Class “A” fire rated PVC vinyl. Pads are easy to install the 2 inch Thick Impact rated polyethylene foam laminated to 7/16 inch oriented strand board covered in Red Class A fire rated 18-ounce vinyl. 1inch nailing margin top and bottom.

Indoor stationary wall padding panel, intended for direct wall connection. The panel is a wood backed pad of inch Impact rated polyethylene foam bonded to the face using a two-part adhesion process. The foam and wood are covered front and sides then firmly stapled onto the back using Class A PVC Vinyl.

Components
1. Backing - 7/16 inch Georgia Pacific Blue Ribbon® oriented strand board (OSB); Third-party
certified to the Sustainable Forestry Initiative® procurement standard, Exposure 1 bond
durability. Contains no added urea formaldehyde resins. Georgia-Pacific building
products can contribute to LEED® certification points.
2. Foam Layer - 2 inch polyethylene foam meets standards for ASTM 2440. The test method
quantifies impact in terms of g-max and Head Injury Criterion (HIC) scores. Promotes
closed-loop recycling of post-industrial scrap. Contains at least 60% and up to 100%
recycled pre-consumer raw material. The use of pre-consumer recycled material can
contribute to LEED® certification points.
3. Covering - 18 oz. laminated leather grain embossed vinyl BACshield: Anti-Mildew,
Anti-Fungus, Antimicrobial, Antibacterial treated, UV treated. Passes ASTM E84 (Class A),
NFPA-701 & Cal 117 FR tests C.P.S.I.A. Certified.

STANDARD MANUFACTURING
Typical panel to be manufactured at 24 inch width by specified height.
All columns and corners to be pre-fabricated to fit field condition

INSTALLATION
1. 1 inch Nail Margin top and bottom along width edge attached directly to wall using
appropriate hardware for wall type. Refer to ASTM standards for height above finished
floor. 4 inch AFF to bottom of foam current. Shipping

Ships via freight delivery shrink wrapped on pallets

This Product Ships Freight Only.
Please review our shipping disclaimer.

Ask a question about this product