SupraTile Ramp Interlocking Edge 4 Pack 2.5 Inch Wide

1. Connect to main tiles to finish the look
2. Oil and chemical resistant, mold and mildew resistant
3. Provides transition on and off the flooring
4. Can be installed over old uneven, or contaminated sub-floors
5. Easy to remove and relay, protective topcoats available

Matching interlocking edging. Available in 'straight', which match up with a single tile edge, or 'corner' which has an extension creating a 'miter look' clean joint on corners. In the photo the piece on the left is a 'straight' and the piece on the top is a 'corner'

Sold in 4 packs only. Each piece is approximately 2.5 inch deep x length of your tile and creates a smooth transition ramp. Teeth can be cut off and glued flush against tiles if needed at a point where teeth have been removed for trimming/fitting. To calculate how many packs you need, take the number of inches that you need and divided by the size of your tile (20 inch for 4mm Dovetail, 20.5 inch for 4.5mm, 6.5mm and 7mm), this gives you the number of pieces you need, and then round that number into the number of 4-packs you need.

Please note that interlocking edging is not available for either the 5.5mm or 7mm hidden joint series, please contact us for edging options.

Installation note: Edging is manufactured from different batch lots than tiles and may require heating with a heat gun or similar to soften the edging temporarily to assure proper fit and alignment. Inexpensive heat guns can be purchased locally at home centers or online.

Maintenance

Clean with damp mop, hot water and common household floor cleaner.

Shipping

Ships in cartons via ground service to your door, for larger orders product may ship freight delivery.

Please review our shipping disclaimer.

WARNING: This product can expose you to chemicals including Lead and/or Phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.