Safety Wall Pad 2x6 Ft x 2 Inch, Indoor Wall Padding

1. Certified OSB
2. Impact rated polyethylene foam
3. Class A fired PVC Vinyl
4. 2 inch thick foam
5. 18 oz vinyl covering
6. Leed certification
7. Contains at least 60% recycled pre-consumer raw material
8. Anti-Mildew, Anti-Fungus, Antimicrobial, Antibacterial treated

The right materials to make your project the very safest, it is certified OSB, Impact rated 1.7 lb / CF polyethylene foam, and Class 'A' fire rated PVC vinyl. Pads are easy to install the 2 inch Thick Impact rated polyethylene foam laminated to 7/16 inch oriented strand board covered in Red Class A fire rated 18-ounce vinyl. 1inch nailing margin top and bottom.

Indoor stationary wall padding panel, intended for direct wall connection. The panel is a wood backed pad of inch Impact rated polyethylene foam bonded to the face using a two-part adhesion process. The foam and wood are covered front and sides then firmly stapled onto the back using Class A PVC Vinyl.

Components
1. Backing - 7/16 inch Georgia Pacific Blue Ribbon® oriented strand board (OSB); Third-party
certified to the Sustainable Forestry Initiative® procurement standard, Exposure 1 bond
durability. Contains no added urea formaldehyde resins. Georgia-Pacific building
products can contribute to LEED® certification points.
2. Foam Layer - 2 inch polyethylene foam meets standards for ASTM 2440. The test method
quantifies impact in terms of g-max and Head Injury Criterion (HIC) scores. Promotes
closed-loop recycling of post-industrial scrap. Contains at least 60% and up to 100%
recycled pre-consumer raw material. The use of pre-consumer recycled material can
contribute to LEED® certification points.
3. Covering - 18 oz. laminated leather grain embossed vinyl BACshield: Anti-Mildew,
Anti-Fungus, Antimicrobial, Antibacterial treated, UV treated. Passes ASTM E84 (Class A),
NFPA-701 & Cal 117 FR tests C.P.S.I.A. Certified.

STANDARD MANUFACTURING
Typical panel to be manufactured at 24 inch width by specified height.
All columns and corners to be pre-fabricated to fit field condition

INSTALLATION
1. 1 inch Nail Margin top and bottom along width edge attached directly to wall using
appropriate hardware for wall type. Refer to ASTM standards for height above finished
floor. 4 inch AFF to bottom of foam current.

Ask a question about this product