mats, flooring, tile
Search our Site   
GREAT Products, Prices & Customer Service
Athletic Flooring | Industrial Flooring | Residential Flooring
Full Product List | Flooring Specials | Purchase Online
 
Back to Product Page

    1-877-822-6622  /  info@greatmats.com

Installing a Wooden Dance Floor Pro Floor
Wood Dance Floor Pro Installation
  1. Start laying floor in upper left corner. All panels must be laid with aluminum splines in the top and left positions.

  2. Depending on the floor, the floor tool may not be needed. If needed, place floor tool under the floor panel to the left of the panel being laid. This allows the panel to be lifted so the clips on the panel being installed slide into place more easily.

  3. Slide panel being laid into place with clip sliding under panel on left.

  4. If you encounter resistance, do not jump on floor to force panels into place. The problem could be a tight or bent clip, if so, bend clip back slightly.

  5. To insure proper placement of edge pieces it is important to start with a corner set. Please note: once corner set is placed properly you will notice that edge pieces are placed in the middle of the two panels. The top row and left column must be at 90 degrees or less. If this is more then 90 degrees, you will experience problems laying the last few sections of the floor.

TIP - The top row and left column must be at 90 degrees or less. If this is more then 90 degrees, you will experience problems laying the last few sections of the floor.

Disassembling a Wooden Dance Floor Pro
  1. To disassemble floor, start by removing the bottom right panel. Using a firm grip on the bottom of the left corner of the panel, pull hard with a snapping motion.

  2. Once loose, while pulling down with your left hand, push in with your right hand on the top right of the panel to clear the connection system. Keep panel level, do not pull up on the panel as that may damage or bend splines.

Storage and Maintenance
It is advisable to clean your floor after each use to prevent a build up of dirt. Start by using a dry mop to remove loose debris and if required, use a lightly damp cloth for general cleaning. For harder stains such as ink, gum or spills use denatured alcohol.

Floor sections should be stored standing up (on their side), wood-to-wood and metal-to-metal, on the Wooden Dance Floor Pro transport cart.

Sections should be stored completely dry and indoors in a climate-controlled location. Exposure to extreme temperature variations should be avoided. Do not leave outdoors overnight.



 
ATHLETIC FLOORING
 
INDUSTRIAL FLOORING
 
RESIDENTIAL FLOORING
 


GREATMATS.COM
117 Industrial Avenue, Milltown, WI 54858
Customer Service Toll Free 1-877-822-6622
Fax Toll Free: 1-866-895-5550
Direct Voice: 1-715-825-4926
Direct Fax: 1-715-825-4928
Email: info@greatmats.com
http://www.greatmats.com