• 1. Sweep the floor clean. Dry vacuum to ensure any fine soil is removed.
• 2. Wet scrub floor with diluted TASKI Profi cleaner (6-8 oz/gl ) using buffer or autoscrubber with TASKI contact pad or soft nylon brush.
• 3. Wet vacuum soiled solution, rinse, and allow to dry thoroughly (6-8 hours).

• Apply 2-3 thin coats of Vision Matte.
• Allow proper drying time before applying next coat.
• Note: Apply floor finish with synthetic wax mop. While the finish is wet, buff the floor with floor buffer (150-300 rpm) and soft nylon brush. This application drives the finish into the floor and prompts proper sealing and coating of the floor.

• 1. Dry vacuum floor thoroughly(daily).
• 2. Auto scrub or wet mop floor using TASKI Combiplus or TASKI Wiwax. (2-3 oz/gl)
• Note: In an office environment, the floor may become scuffed due to heavy foot traffic and may require weekly or as needed spray buffing or dry buffing of the floor with a mint or white pad. In application of spray buffing use TASKI Wiwax diluted 50/50 with water.

• 1. Dry vacuum floor thoroughly.
• 2. Wet scrub floor with TASKI Profi (4 oz/gl). This application is done with an autoscrubber or buffer and wet vacuums. Use TASKI purple pad for scrubbing the floor.
• 3. Allow solution to remain on the floor for 5 minutes.
• 4. Wet vacuum soiled solution. Rinse and allow to dry (1-2 hours).
• 5. Apply 1-2 thin coats of TASKI Vision Matte using wet buffing with soft nylon brush.

• 1. Use high CFM vacuum to pick up dust.
• 2. Wait for floor to dry between applications of floor finish or sealer.
• 3. Apply floor finish (thin coats) with wax mop and follow floor buffer with a soft nylon brush.
• 4. For large areas, use an autoscrubber with a contact pad or soft nylon brush to clean the floor daily.
• 5. For stripping a rubber floor, use TASKI Ice-It and nylon brush.
• 6. For poorly maintained floors, it may be necessary to continue cleaning with Ice-It for an extended period.
• 7. For food areas: cleaning should be done with Profi (2-4 oz/gal).
• 8. Removing gum: use a generic gum remover. If solvent is used, floor must be rinsed with water to prevent solvent damage to floor.
• 9. For areas with high traffic, floors may be top scrubbed and recoated as needed.

Copyright © 1999-2008 GREATMATS.COM Corporation. All rights reserved.